Window Decal Application Instructions
Failure to follow any of these instructions may result in damage to the decal and may cause the decal not to adhere properly. The decal might not be safe for use on the windows of cars, trucks, buses, or other moving vehicles, as it may block or impair the drivers vision. Be smart with where you apply your new JDF Decal.
Step 1 – Clean the area thoroughly with rubbing alcohol or soap and water. Do not use Windex or similar products because it will leave a residue behind that will prevent the sticker from adhering well.
Step 2 – Prepare the sticker for application by firmly rubbing a squeegee or credit card across the clear transfer tape. This removes any air bubbles that may have formed and makes the sticker cling to the transfer tape.
Step 3 – Peel the white paper backing off the sticker. If the sticker clings to the backing, slowly replace the paper backing and repeat Step 2.
Step 4 – Slowly lower the sticker onto the surface and rub it in place firmly with a squeegee or credit card. For best results, wait 15-30 minutes before moving to the next step.
Step 5 – Slowly peel the clear transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.